Mounting The Cisco Controller 200 On A Wall - Cisco SCH-CONTROL-200 Reference Manual

This document, and other related documents, are available online at
Note
www.cisco.com/go/smartconnectedresidential/docs.
page 11

Mounting the Cisco Controller 200 on a Wall

The Cisco Controller 200 can be mounted on a wall or placed on a horizontal surface (such as a shelf).
Procedure
To mount the device on a wall:
Select one of the following mounting options:
Step 1
•
•
•
Note
OL-27357-01
for more information.
Mount the Controller 200 horizontally using one (1) standard single-gang wall box. The wall
mounting plate has four (4) horizontal sets of slots. Leave the screws protruding .08" from the wall.
Mount the Controller 200 horizontally or vertically using one (1) standard double-gang box. Leave
the screws protruding .08" from the wall.
Mount the Cisco Controller 200 horizontally or vertically using four (4) screws (not provided)
placed directly into a wall stud or studs.
Using the mounting plate as a template, screw four (4) screws into a stud to align with the four
–
(4) center slots for vertical positioning; or into two (2) studs to align with the four (4) corner
slots for horizontal positioning.
– Leave the screws protruding .08" from the wall.
To quickly check the fit of the screws, place the wall mounting plate over the screws before
attaching it to the bottom of the Controller 200.
Mounting the Cisco Controller 200 on a Wall
See the "Related Documentation" section on
Cisco Smart+Connected Controller 200 Reference Guide
3