Measuring The Rear Height H2M; Adjusting The Heights - CITROEN C5 2005 Service Manual

C5 DRAINING - FILLING - BLEEDING: HYDRAULIC SUSPENSION/STEERING CIRCUIT
B3DP08HC
B3CP06CC

Measuring the rear height H2M.

The rear height H2M is measured between the ground and the zone "a" on the crossmember.
Calculating the rear height H2C.
Except CARLSSON
CARLSSON
R2 = Radius of rear wheel (mm).
Compare:
- The value measured H2M.
- The value calculated H2C.
Adjust the rear height if necessary.

Adjusting the heights.

Adjustment using a diagnostic tool.
This adjustment is done when the heights measured are within the tolerance of the heights calculated.
Mechanical pre-adjustment.
This adjustment is done when the heights measured are not within the tolerance of the heights calculated
(± 10 mm).
Front height:
- Slacken, by one turn, the screw (1) on the clip (2).
- Retighten the screw by hand.
- To decrease the height, turn the clip (2) towards the front of the vehicle.
- To increase the height, turn the clip (2) towards the rear of the vehicle.
Repeat the operation until you obtain the calculated dimension H1C (± 10 mm).
Tighten the screw (1) to 0,6 m.daN.
Adjust with diagnostic tool [2] or [3].
318
: H2C = R2 + 68 mm.
: H2C = R2 + 64 mm.