ZyXEL Communications armor z2 NT8700-ROG User Manual page 145

Click Expert Mode > Security > IPv6 Firewall. The IPv6 Firewall screen appears as shown.
Figure 97 Expert Mode > Security > IPv6 Firewall
The following table describes the labels in this screen.
Table 52 Expert Mode > Security > IPv6 Firewall
LABEL DESCRIPTION
Enable Firewall Rule
Enable Firewall Rule Select this check box to activate the firewall rules that you define (see Add Firewall
Rule below).
Action Select DROP to silently discard the packets which meet the firewall rules. The others
are accepted.
Select ACCEPT to allow the passage of the packets which meet the firewall rules. The
others are blocked.
Add Firewall Rule
Service Name Enter a name that identifies or describes the firewall rule.
MAC Address Enter the MAC address of the computer for which the firewall rule applies.
Dest IP Address Enter the IPv6 address of the computer to which traffic for the application or service is
entering.
The NBG6817 applies the firewall rule to traffic destined for this computer.
Source IP Address Enter the IPv6 address of the computer that initializes traffic for the application or
service.
The NBG6817 applies the firewall rule to traffic initiating from this computer.
Protocol Select the protocol (TCP, UDP or ICMPv6) used to transport the packets for which you
want to apply the firewall rule.
Dest Port Range Enter the port number/range of the destination that defines the traffic type, for
example TCP port 80 defines web traffic.
Source Port Range Enter the port number/range of the source that defines the traffic type, for example
TCP port 80 defines web traffic.
Chapter 14 Security
NBG6817 User's Guide
145