ZyXEL Communications armor z2 NT8700-ROG User Manual page 124

Table 43 Expert Mode > Applications > Parental Control > Notification (continued)
LABEL
Status
User Name
Notification
Modify
Email Notification Configuration
Mail Server
Mail Server
Address
Mail Server Port
Authentication
Username
Authentication
Password
Mail From
E-Mail
Apply
Cancel
13.2.2.1 Add/Edit a Notification Rule
Click Add new rules in the Notification screen to add a new rule or click the Edit icon next to an
existing rule to edit it. Use this screen to set a schedule and have the NBG6817 send a notification
when the specified user connects to the NBG6817 at the scheduled time.
Figure 83 Expert Mode > Applications > Notification: Add/Edit new rules
Chapter 13 Applications
DESCRIPTION
This indicates whether the rule is active or not.
A yellow bulb signifies that this rule is active. A gray bulb signifies that this rule is not active.
This shows the name of the user to which this rule applies.
This shows the e-mail address to which the notification is sent.
Click the Edit icon to go to the screen where you can edit the rule.
Click the Delete icon to delete an existing rule.
Select the mail server. Otherwise, select UserDefined and manually specify the mail server
address and the port of the mail server.
Type the name or IP address of the outgoing SMTP server.
Enter the same port number here as is on the mail server for mail traffic.
Type the user name to provide to the SMTP server for authentication when the notification is
e-mailed.
Type the password to provide to the SMTP server for authentication when the notification is
e-mailed.
Type the e-mail address from which the outgoing e-mail is delivered. This address is used in
replies.
Type the e-mail address (or addresses) to which the outgoing e-mail is delivered.
Click Apply to save your changes.
Click Cancel to restore your previously saved settings.
NBG6817 User's Guide
124