The instructions require that your hardware is connected (see the Quick Start Guide) and you are
logged into the Web Configurator through your LAN connection (see
Make sure the WIFI switch (at the back panel of the NBG6817) is set to ON.
1
Open the Expert > Wireless > Wireless screen in the AP's Web Configurator.
2
Confirm that the wireless LAN is enabled on the NBG6817.
3
Select to configure the wireless settings for the 2.4GHz wireless radio.
4
Enter SSID_Example3 as the SSID and select Channel-06 as the channel. Set security mode to
5
WPA2-PSK and enter ThisismyWPA-PSKpre-sharedkey in the Pre-Shared Key field. Click
Apply.
Click Expert > Status to open the Status screen. Verify your wireless and wireless security
6
settings under Device Information and check if the WLAN connection is up under Interface
Status.
Chapter 8 Tutorials
NBG6817 User's Guide
52
Section 2.2 on page
15).