Quick reference page ..............3 Indicator lights ................4 Overview ..................5 First time setup ................6 Connecting iCube II to your computer ...........7 Battery status ................8 Operating time ................8 Using iCube II with a patient ............8 Using iCube II without a patient ............9 Important information ..............10...
Left and middle Programming remains solid complete indicator rapidly left hearing green blinking for instrument 2 seconds Middle indicator is iCube II 2 sec All indicators Pairing mode solid green for two starting up rapidly blinking enabled seconds back and forth Middle indicator...
Overview iCube II enables the wireless transfer of fitting data from your computer directly to your patient’s hearing instruments. Use the diagram to identify the components of the iCube II programmer. iCube II accessories iCube II desktop stand • USB hub •...
USB port on your computer Turning iCube II on/off system. To turn on your iCube II, slide the switch to the on If you use the iCube II desktop or off position, as shown. Once your iCube II is fully stand, install it as shown.
A. Using a wired USB connection of up to 10 meters (33 ft.) of the fitting computer. Using a USB cable, connect the iCube II to a spare USB Put the iCube II into pairing mode by pressing the pairing slot on your computer.
If you wish to delete the Bluetooth pairing from your While turned on, your iCube II indicates the battery iCube II, press and hold the pairing button for about ten status on the middle indicator as follows: seconds until the middle indicator is lit solid blue.
Unplug the charging cable from the iCube II and positioned inside the loop. turn it on. Make sure that iCube II is selected and shown as the fitting device in Hansaton scout. Wearing iCube II Make sure both ends of the neckloop are firmly plugged into the iCube II.
When iCube II is not in use, turn it off and recharge it and experiences virtually no interference from other so it will be sufficiently charged and ready for the devices.
Page 11
(e.g. wearing the USB cable around a modified device. the neck) can cause injury. If you use several iCube II devices in the same building, Do not connect an USB cable exceeding 3 meters (9 be aware that their inductive field can disturb one feet) in length to the device.
Possible remedy Cause Possible remedy A second or different iCube II cannot be connected to the iCube II is no longer recognized by the computer to which it was previously paired fitting PC The iCube II USB adapter Plug in the iCube II USB adapter...
Declaration of conformity Notices Unitron Hearing declares under its sole responsibility Notice 1 that the iCube II is in conformity with the following This instrument is certified under: standards or other standardizing documents: FCC ID: KWC-ICube2 Radio: EN 300-330 IC: 2262A-ICube2...
Page 14
The CE symbol is confirmation by Unitron that this Notice 3 Unitron product meets the requirements of directive This equipment has been tested and found to comply 93/42/EEC on medical devices and the R&TTE Directive with the limits for a Class B digital device, pursuant to 1999/5/EC on Radio and Telecommunication Terminal Part 15 of the FCC Rules.
Page 15
Australia & New Zealand Brazil China Japan South Korea...
Page 16
For more than 55 years, we at Hansaton have been Unitron Hearing 20 Beasley Drive, P.O. Box 9017, helping people with our devices to achieve better hearing Kitchener, ON N2G 4X1 Canada and better speech understanding, thus a higher quality Unitron Hearing GmbH of life.
Need help?
Do you have a question about the iCube II and is the answer not in the manual?
Questions and answers