Switching The Dishwasher Off; Interrupting The Programme - Siemens sl65a590 Instructions For Use Manual

en

Switching the dishwasher OFF

Several minutes after the programme has
ended:
Open the door when the programme
has ended.
Set main switch
Turn the water tap off.
(Does not apply when Aqua-Stop unit
has been fitted)
Remove dishes, etc. when they have
cooled down.

Interrupting the programme

Open the door. Caution! There is a risk
of water squirting out from inside the
appliance. Do not open the door fully
until the spray arm has stopped
rotating.
Set main switch
Indicator lights extinguish. The
programme is retained in the dish-
washer memory.
If the hot water was switched ON or the
appliance has already heated up and
then the appliance door opened, leave
the door ajar for several minutes and
then close.
Otherwise, the appliance door may fly
open due to expansion.
In order to continue with the stored
programme, set the main switch to ON
again and close the door.
38
to OFF.
1
to OFF.
1
Programming the timer
You can delay the start of a programme in
increments of one hour for up to 19 hours.
Switch dishwasher ON.
Immediately press the TIMER button
. The numerical display
3
changes to .
Press the TIMER button as many times
as necessary until the numerical display
shows the required delay.
To erase the time delay setting, keep
pressing the TIMER button until
appears in the numerical display.
You can change your programme
selection as often as you like during the
intervening period before the dish-
washer starts up.
Time-remaining indicator
The time-remaining indicator is
self-learning. When the programme
begins, it displays the estimated duration
of that programme. This figure is based
upon the duration of the previous
programme, or if the dishwasher is being
used for the first time, the duration of the
programme used for testing the appliance
in the factory. While the programme is
running, the indicator shows the amount of
time before the programme ends. The time
remaining is also adjusted to account for
the temperature of the water supply and
the number of dishes.
Intensive drying function
Activating the intensive drying function
increases the temperature during the
rinse-aid stage which gives better drying
results.
Press and hold the A programme
button, and set the main switch
ON.
Release both buttons.
Either (ON) or
the numerical display
Press the A programme button to
change the setting.
Set the main switch
new setting is stored in the dishwasher
memory.
4
to
1
(OFF) flashes in
.
4
to OFF. The
1