Switching The Dishwasher Off; Interrupting The Programme; End Of Programme - Siemens Dishwasher Instructions For Use Manual

Table of Contents

Advertisement

Switching the dishwasher ON
Turn on the tap.
Set main switch
Indicators light up according to the last
programme that was selected.
This same programme will run again if
no other programme button
pressed
The numerical display
expected duration of the programme.
Close door.
The programme starts automatically.

End of programme

The end of the programme is indicated by
a buzzer. This function can be changed as
follows:–
Hold down Function button C
pressed and switch on main switch
, then let the buttons go.
1
Function Button C flashes, and the
digital display indicates the value
which was set at the factory
(semi-loud).
To change the setting:
Press Function button C .
Each depression of the button
increases the set value by one,
when
is reached, the display
jumps back to
Switch off the main switch
The set value is stored in the appliance.
to ON.
1
is
7
shows the
4
(off).
.
1

Switching the dishwasher OFF

Several minutes after the programme has
ended:
Open the door when the programme
has ended.
Set main switch
Turn the water tap off.
(Does not apply when Aqua-Stop unit
has been fitted)
Remove dishes, etc. when they have
cooled down.

Interrupting the programme

Open the door. Caution! There is a risk
of water squirting out from inside the
appliance. Do not open the door fully
until the spray arm has stopped
rotating.
Set main switch
Indicator lights extinguish. The
programme is retained in the dish-
washer memory.
If the hot water was switched ON or the
appliance has already heated up and
then the appliance door opened, leave
the door ajar for several minutes and
then close.
Otherwise, the appliance door may fly
open due to expansion.
In order to continue with the stored
programme, set the main switch to ON
again and close the door.
en
to OFF.
1
to OFF.
1
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents