Download Print this page

Washing Dishes - Siemens sl65a590 Instructions For Use Manual

Hide thumbs

Advertisement

Washing dishes

Reduce costs!
If only a small number of
dishes have been loaded into
the dishwasher, selecting a
programme that operates at
the next lowest temperature
will usually suffice.
Programme data
The stated programme data are based on
standard operating conditions. The values
can vary considerably according to:
different amounts of dishes
temperature of mains water supply
pressure of mains water supply
ambient temperature
fluctuations in mains voltage
machine-related factors (e.g.
temperature, water volume, ...).
Energy and water consumption is reduced
by up to 1/4 when dishes are washed in
the upper basket only.
Water consumption values are based on a
water hardness setting of 4.
Aquasensor
The Aquasensor is an optical measuring
device with which the cloudiness of the
water in the dishwasher is measured. A
photoelectric sensor is used to detect the
degree of soiling in the water, caused by
dissolved food particles such as egg, fat
and rolled oats, etc.
The Aquasensor functions during all
programmes that include a pre-rinse cycle.
If the water is still "clean" at the end of the
pre-rinse cycle, then the same water is
used for the following wash cycle. If the
water is dirty, it is pumped out of the
dishwasher and replaced by fresh water.
The effect is to reduce water consumption
by approx. 4 litres when the dishes are
only "slightly" dirty.
Switching the dishwasher ON
Turn on the tap.
Set main switch
Indicators light up according to the last
programme that was selected.
This same programme will run again if
no other programme button
pressed
The numerical display
expected duration of the programme.
Close door.
The programme starts automatically.
End of programme
The end of programme is indicated by
a buzzer.
This function can be changed as follows:
Hold down the Time delay programme
button
and switch on the Main
3
switch
, then release the buttons.
1
The Time delay button
the digital display indicates the value
(loud) which was set at the factory.
To change the setting:
Press the Time delay programme
button
.
3
Each depression of the button
increases the set value by one; when
is reached, the display jumps back
to
(off).
Switch off the Main switch
value is stored in the appliance.
en
to ON.
1
is
7
shows the
4
flashes and
3
. The set
1
37

Hide quick links:

Advertisement

loading

This manual is also suitable for:

Family line 01805-2223