Chicco KeyFit 30 User Manual page 56

INSTALL USING LAP-SHOULDER BELT
Put the vehicle seat belt in the locked mode, see vehicle owner's manual for more
information. A tightly rolled towel may be used under the front edge of the
Carrier if needed to adjust the angle of the Carrier. Angle is correct when level line
on Carrier is level with ground.
While pushing down on the Carrier, pull up on the vehicle shoulder belt to
3
remove all slack from vehicle lap belt.
CHECK YOUR WORK
Hold Child Restraint at each side and pull side to side and forward.

Child Restraint should not move more than 1" (25 mm) from vehicle seat
back or side-to-side.
Make sure Child Restraint is level. Make sure infant's head does not fall

forward. If necessary re-adjust recline and repeat installation steps to
make sure Child Restraint is installed properly.

Check installation before every use!
54