Cassette Recorder - Philips AZ5160 User Manual

CASSETTE PLAYBACK
1. Set the source selector to TAPE/OFF.
2. Press 9 / to open the cassette holder.
3. Insert a recorded cassette.
4. Press 1 and playback will start.
5. Adjust the sound using the VOLUME and DBB controls.
6. For brief interruptions, press ;. Press ; again to resume
playback.
7. By pressing 5 or 6,fast winding of the tape is possible in
both directions.
8. To stop playback, press 9 /
™ The keys are automatically released at the end of the tape.
9. Set the source selector to TAPE/OFF position (with the
cassette keys released) to switch off the set.
Note : During playback, the keys are automatically released at the end of a tape and the set is
-
switched off (unless PAUSE mode ; has been activated.)
During fast forwarding/rewinding, the keys will not be released at the end of a tape. To
-
switch off the set, make sure the cassette keys are also released.
CASSETTE RECORDING
General information on cassette recording
• Recording is permissible insofar as copyright or other rights
of third parties are not infringed.
• This deck is not suitable for recording on CHROME (IEC II)
or METAL (IEC IV) type cassettes. For recording you should
use NORMAL type cassettes (IEC I) on which the tabs have
not been broken.
• Check and tighten slack tape before use with a pencil to avoid
jamming the deck machanism.
• The recording level is set automatically.
Note : - No recording will take place during the 7 seconds in the
beginning of the tape.
• To prevent the accidental erasure of a recording, keep the cassette side to be safeguarded in
front of you and break out the left tab. Recording on this side is no longer possible.
The making of unauthorized copies of copy-protected material, including computer
programmes, files, broadcasts and sound recordings, may be an infringement of
copyrights and constitute a criminal offence.
This equipment should not be used for such
purposes.
18

CASSETTE RECORDER

1