Replacing The Vacuum Lips; Install D Cleaning Head; Install R Cleaning Head - Kärcher B 150 R Instructions Manual

 Turn the protective turbine strainer in a
counter-clockwise direction.
 Remove protective turbine strainer.
 Rinse dirt off the protective turbine
strainer with water.
 Reattach protective turbine strainer.
 Attach float.

Replacing the vacuum lips

 Remove the vacuum bar.
 Unscrew the star grips.
 Remove the plastic parts.
 Remove the vacuum lips.
 Insert new vacuum lips.
 Insert the plastic parts.
 Screw in and tighten the star grips.

Install D cleaning head

 Lift the holder of the cleaning head (see
Chapter "Grey intelligent key/.../clean-
ing head replacement".
 Slide the cleaning head under the appli-
ance so that the hose points toward the
rear.
Only slide the cleaning head halfway
under the appliance.
 Remove the lid of the cleaning head.
 Connect the power cord of the cleaning
head to the appliance (same colours
must meet).
 Replace the lid and lock it.
 Slide the cleaning head halfway under
the appliance.
 Connect the hose couplers on the
cleaning head to the hose on the appli-
ance.
 Insert the tab into the middle of the
cleaning head, between the fork of the
lever.
 Align the holder of the cleaning head so
that the drilled holes in the lever and the
cleaning head match.
 Insert the stop pin through the bushings
and swivel the locking plate downward.
 Insert the cylinder pin into the boring of
the drawbar.
 Slide the drawbar with the pin the guide
channel on the cleaning head all the
way to the bottom.
 Insert the locking plate into the guide
channel and lock it in.
 Repeat process on the drawbar on the
opposite side.
 Insert the grey intelligent key.
 Set brush type "Disc".

Install R cleaning head

 Lift the holder of the cleaning head (see
Chapter "Grey intelligent key/.../clean-
ing head replacement".
 Slide the cleaning head under the appli-
ance so that the hose points toward the
rear.
Only slide the cleaning head halfway
under the appliance.
9
-
EN
 Unscrew the star handle and remove
the lid.
 Connect the power cord of the cleaning
head to the appliance (same colours
must meet).
 Slide the lid in and screw tight.
 Slide the cleaning head halfway under
the appliance.
 Connect the hose couplers on the
cleaning head to the hose on the appli-
ance.
 Insert the tab into the middle of the
cleaning head, between the fork of the
lever.
 Align the holder of the cleaning head so
that the drilled holes in the lever and the
cleaning head match.
 Insert the stop pin through the bushings
and swivel the locking plate downward.
25