WARNING
Before replacement of the parts, be sure to stop
operation of the air conditioner and turn switch of the
breaker.
Replacing the fan motor
1
Remove the electrical control cover.
(2 screws)
2
Remove the fan motor lead.
(1) Remove the fan motor lead
connector. (3 positions)
(2) Remove the fan motor lead from the
terminal board (terminal No. F1 –
F3). (3 positions)
3
Remove the TC1 / TC2 / TA / TCJ
sensor leads and PMV coil lead from
the control circuit board connector.
4
Remove the electrical control box
from the side board. (2 screws)
5
Remove the side board from the main
unit. (M5 screws, 8 pcs)
6
Remove the three screws fixing the
fan assembly, and slide the assembly
along the guide rail to pull it out. (3
M5 tap tight screws)
7
Loosen the screws fixing the fan.
(M8)
8
Remove the two screws fixing the
motor band.
9
Replace the motor.
10. DETACHMENTS
CAUTION
Be sure to put on the gloves at disassembling work:
otherwise an injuly will be caused by a part. etc.
TC1 / TC2 / TCJ
sensor leads
PMV coil lead
TA sensor
lead
Electrical
control
box
Screws
Motor band
Fan case
Fan motor
M5 screws, 3 pcs
Motor band
Fan case
Fan motor
M5 screws, 3 pcs
– 73 –
Side
board
Electrical
control box
cover
Fan motor lead
connector
Fan
Fixing screw
Fan
Fixing screw
Fan motor
lead
Terminal
board
Electrical control box
Guide rail
Guide rail