Table of Contents
Advertisement
8-3. Method to Set Indoor Unit Function DN Code
(When performing this task, be sure to use a wired remote control-
ler.)
<Procedure> To be performed only when system at rest
1
SET
Push the
+
least 4 seconds.
The unit No. displayed first is the address of the header indoor unit in
group control.
Then the fan and louver of the selected indoor unit move.
2
Each time the "Select unit" side of the
one of the indoor unit Nos. under group control is displayed in
turn. Then the fan of the selected indoor unit move.
3
TEMP.
Use the
button to select the CODE No. (DN code) of the
desired function.
4
Use the
button to select the desired SET DATA associated
with the selected function.
5
SET
Push the
button. (The display changes from flashing to
steady.)
• To change the selected indoor unit, go back to step
• To change the selected function, go back to step
6
SET
When the
button is pushed, the system returns to normal off state.
CL
+
buttons simultaneously and hold for at
UNIT LOUVER
button is pushed,
2
.
3
.
– 31 –
SET DATA
00 01
SETTING
TEST
UNIT No.
1-1
R.C.
No.
TEMP.
ON / OFF
TIMER SET
FAN
TIME
SAVE
FILTER
RESET
TEST
SET
CL
SWING/FIX
5
4
3
1
6
10
CODE No.
MODE
VENT
UNIT LOUVER
2
Advertisement
Table of Contents
Troubleshooting
