Mode; Answer Mode Setting; Built-In Ogm (Out Going Message) - Sanyo sfx-32 Instruction Manual

38
Answer mode setting
Press ~SWE~ to set the answer
mode.
. Answer lamp lights and the out go-
ing message (OGM) is released from
speaker.
"No one is here now at this moment,
please leave your message after the
tone. If you want to send a fax mes-
sage, please press the m] key."
(See built-in OGM in this page.)
The SFX-32 records all of the incoming messages (lCM), MEMO and your
own OGM into the IC memory. The recording capacity is maximum 18-
minute in total.
No matter which position of the reception mode (AUTO/MANU) is selected.
Answer mode has a priority once it is selected.
I To cancel Answer mode I
Press ~1 again.
The answer lamp is turned off and the ANSWER mode is cancelled.
The following Out Going Message (OGM) is prepared for the built-in TAS
operation.
Both ICM recording and Fax receiving are available:
"Sorry but no one is here at this moment, please leave your message after the
tone. If you want to send a fax message, please press the ml key."
ICM recording is not available (memory full or maximum number) but Fax
receiving is available.
"Sorry but no one is here at this moment. If you want to send a fax message,
please press the ~] key."
No Fax receiving is available (No recording paper is installed or run out of the
recording paper) but ICM recording is available.
"Sorry but no one is here at this moment.
Please leave your message after the tone."
Both ICM recording and Fax receiving are not available.
"Sorry but no one is here at this moment, please call later
In addition to the above built-in messages, your own OGM can be recorded
(see page 42). Once you have recorded your own OGM, it will be released at
any case described above.