Sunrise Medical Breezy Easy Start Manual page 3

Wheels
1. To remove the wheels, depress the quick-release button fully and pull
the wheel out of the hub as shown.
2. When installing wheels on your chair, always check to make sure that
the axles have been locked into place.
3. Depress the quick-release button fully, and insert the axle through
the hub of the rear wheel and release the button.
4. Pull on the wheel to make sure it is fully inserted, and locked. Repeat
these steps on the other side of your chair.
5. Have your Premium Retailer adjust the axle if it does not lock.
6. You may remove the wheels for transport or storage.
Unfolding or folding
1. When unfolding your chair, ALWAYS use the flat of your palms while
pushing down on the seat sling. Push down without wrapping your
fingers around the seat rail to avoid any pinch points.
2. Stand to one side of the chair, tilt the chair toward you slightly, and
push down on the seat rail closest to you, the chair should open fully.
3. Make sure the seat rail tubes snap into the frame saddles, by using
your palms to push down on both sides.
4. When folding your chair, check to make sure the footrests are either
removed or that the footplates are folded.
5. Remove the cushion.
6. Grasp the center of the seat sling and lift up until the chair folds flat.
Footrest
1. To install your footrest, place the plastic pivot and saddle into the re-
ceiver on front frame tube with the footrest facing outward from
the frame.
2. Rotate the footrest inward until it locks into place on the hanger
latch block.
3. To remove footrest, pull the release lever toward the frame.
4. As you continue to hold the lever, rotate the footrest outward and
lift it off.