Operation; Maintenance - Makita HK1820 Instruction Manual

cannot be disconnected from the connector of extension
cord. Set it on the extension cord 10 cm - 20 cm away
from the connector of the extension cord.

OPERATION

Fig.9
Position the bit at the location to be chipped, then pull
the switch trigger. Apply slight pressure on the tool so
that the tool will not bounce around, uncontrolled.
Pressing very hard on the tool will not increase the
efficiency.
Fig.10
NOTE:
When removing tiles with a scaling chisel, apply
•
the chisel to the bottom of tiles as shown in the
figure. If you operate the tool with the chisel
applied to the top surface of tiles, the service life of
the chisel will be shortened.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Bull point
•
Cold chisel
•
Scaling chisel
•
Bit grease
•
Safety goggles
•
Hammer grease
•
Hook
•
or attachments
Only use accessory or
are
5