The Upright Wire (72) - NordicTrack NTL15008.1 User Manual

5. Slide the two Handrail Covers (76) onto the
lower ends of the Left and Right Handrails (69,
75). See the inset drawing. Make sure that
the curved end of each Handrail Cover is fac-
ing the Upright (74).
Slide the lower ends of the Handrails (69, 75)
onto the brackets on the Upright (74).
Attach each Handrail (69, 75) to the Upright (74)
with two 1/4" x 1" Bolts (32) and two 1/4" Flat
Washers (25); do not fully tighten the Bolts
yet.
6. Hold the Yoke Spacer (87) near the Upright
(74). Make sure that the curved side of the
Yoke Spacer is facing the Upright. Insert the
Upright Wire (72) through the Yoke Spacer and
the Yoke (88).
Attach the Yoke (88) and the Yoke Spacer (87)
to the Upright (74) with two 3/8" x 5" Bolts (7)
and two 3/8" Star Washers (9). Firmly tighten
the Bolts.
Remove the wire ties from the Upright Wire (72)
and the Pulse Wires (70, 71).
Firmly tighten the 5/16" x 3/4" Bolts (6).
See step 5. Firmly tighten the 1/4" x 1" Bolts
(32), and slide the Handrail Covers (76) down
over the Bolts and against the Upright (74).
5
69
70
74
76
Bracket
25
32
76
Curved End
6
88
6
70
72
Wire
Ties
9
71
75
76
Bracket
25
32
74
7
9
87
71
6
Curved
Side