Advertisement
The phone will not work if the phone plug or power
Power is not correctly connected.
Page 9
9
Connections base
Residences or offices with internet
broadband (ADSL)
In addition, charge the battery first before plugging the line
telephone.
The device will work only if the battery is completely
loaded.
Make sure that the ADSL micro filter is installed in the same
outlet line from your wireless phone.
If not, ask you for your phone carrier.
Page 10
10
Operating the handset
Operating the handset
The handset will be ready to make or receive calls only
After the first load of 16 hours.
Installation of rechargeable batteries
The bottom of the handset includes a battery compartment
for two rechargeable AAA batteries.
Removing the battery compartment cover
Slide the battery compartment cover down (about 3
mm) and lift.
Installation of two batteries (observe polarity)
Place the two batteries in the battery compartment. Check that the
polarity is correct. Be sure to insert the batteries so
the flat end of the battery (negative terminal) to connect to
Spring contacts. The handset will not work if the batteries are
inserted incorrectly. The incorrect placement can cause damage to
device. Replace the compartment cover, positioning it about
3 mm away and slide it up until you hear the click sound.
Battery charge
ATTENTION
The batteries are not charged. To charge, place the handset
at the base of the device has connected to the power source as
described above. The light icon on the handset battery
signals the loading procedure. The batteries take about
16 hours to complete a full charge.
After that, connect the plug into the phone jack. Now
phone is ready for use.
Advertisement
