Chapter-9: Failure Codes And What To Do İn Case Of Failure - Sharp QW-T13F491W-EU User Manual

CHAPTER -9: FAILURE CODES AND WHAT TO DO IN CASE OF
FAILURE
ERROR ERROR
CODE DESCRIPTION
Inadequate water
F5
supply
Error of continuous
F3
water input
The waste water in the
F2 machine cannot be
discharged.
F8 Heater error
Alarm is active against
F1
water overflow
FE Faulty electronic card
Overheating error
(temperature in the
F7
machine is
too high)
F9 Divisor position error
F6 Faulty heater sensor
If one of the program monitor lights is on and start/Pause light is on and off,
Your machine's door is open, shut the door.
If the programme won't start
• Check if the plug is connected.
• Check your indoor fuses.
• Be sure that the water inlet tap is turned on.
• Be sure that you have closed the machine door.
• Be sure that you switched off the machine by pressing the Power On / Off button.
• Be sure that the water inlet filter and the machine filters are not clogged.
If the lamps "Wash/Dry" and "End" keep flashing
• The water overflow alarm is active
• Turn off your tap and contact the Sharp helpdesk.
If the control lamps won't go out after a wash operation
Check if the Power On/Off button is released.
If detergent residues are left in the detergent compartment
Detergent has been added when the detergent compartment was wet.
If water is left inside the machine at the end of the programme
• The water drain hose is clogged or twisted.
• The filters are clogged.
• The programme is not finished yet.
If the machine stops during a wash operation
• Power failure.
• Water inlet failure.
• Program can be on standby mode.
If shaking and hitting noises are heard during a wash operation
• Dishes placed incorrectly.
• Spray arm hitting the dishes.
If there are partial food wastes left on the dishes
• Dishes placed incorrectly into the machine, sprayed water did not reach related places.
• Basket overly loaded.
• Dishes leaning against one another.
• Small amount of detergent added.
• An unsuitable, rather weak wash programme selected.
• Spray arm clogged with food wastes.
• Filters clogged.
• Filters incorrectly fitted.
• Water drain pump clogged.
CONTROL
• Make sure the water input tap is totally open and that there is no
water cut.
• Close the water input tap, separate the water input hose from the
tap and clean the filter at the connection end of the hose.
• Restart your machine, contact the service if the error resumes.
• Close the tap.
• Contact service.
• Water discharge hose is clogged.
• The filters of your machine might be clogged.
• Power off-on your machine and activate the program
cancellation command.
• If the error continues, contact the service.
• Contact service.
• Power off your machine and close the tap.
• Contact service.
• Contact service.
• Contact service.
• Contact service.
• Contact service.
EN- 25