coM.sat ISDN Basic Manual page 56

coM.sat ISDN Basic
entry, the input box remains blank.
If the GSM network cannot provide real charge information, artificial charge
information (phase) is produced by the "AOC timer". The AOC timer can be adjusted
between 0 and 240 seconds.
The default number is the number of the extension that is called for incoming calls if
"Call Default Number" has been selected. This number is also called if a caller does
not dial anything.
The sound volume of the microphone and handset for the GSM channel can also be
adjusted using this card if the preset level is insufficient. The preset values are 5 for
"Microphone Attenuation" and 4 for "Speaker Volume". Both values can be altered
between 0 - 7, whereby lower values represent lower volume and higher values
higher volume.
The time during which a consecutive number can be dialled is also configurable. The
time span is pre-set to 5 seconds. This should suffice for most applications, but can
be changed in the "Incoming Call Dial Timeout" input box if necessary.
If prepaid SIM cards are used and their credit is set with the command "Set Prepaid
Time" in menu "Info" (see 3.3.15), a threshold can be set in the field "Time too Low".
If the credit falls below this threshold, the channel will not be used anymore. In
addition, an SMS can be sent (see 3.3.3).
Furthermore, the number of the "SMS service centre" must be entered on this card,
which is provided by the respective network provider whose SIM cards are used. The
respective SMS centre can be selected from a list. This list is read in from the
"sms.txt" text file. If one of the numbers given has changed or a new number is to be
added or should the numbers of the network provider outside of the country in which
the TA is installed no longer be visible, the corresponding amendments can be made
by changing the text file. Of course it is also possible to enter any number instead of
selecting one of the list entries.
An "Init String" is usually not needed. In some cases it may be useful to send an
additional command to the GSM modules built into the device not given by the
firmware of the device. Such an additional command can be entered in this field.
The network access numbers can be defined in a list box. This means that the
dialling codes of the network providers that can be used for the calls are entered
here. The numbers are entered as follows:
if e.g. only these two T-Mobile numbers are to be used.
Only one dialling code can be entered in each row.
Note: It is recommended to only make entries if restrictions are actually to be made.
Otherwise it is advisable to leave this list box empty. In a further list box the numbers
of those extensions that may access this GSM channel are set.
created:
16/01/09
0170
0171
page:
56
Note Protection Mark according to DIN 34!
coMsat ISDN Basic Manual V2.7.doc
file: