Warning Display - Zephir ZHC1000 Instruction Manual

button to set the delay time.
You must decide how long it will be before your bread is ready by pressing the
" "or " ". Please note the delay time should include the baking time of
program. That is, at the completion of delay time, there is hot bread can be
serviced. At first the program and degree of browning must be selected, then
pressing " "or " "to increase or decrease the delay time at the increment of
10 minutes. The maximum delay is 13 hours.
Example: Now it is 8:30p.m,if you would like your bread to be ready in the
next morning at 7 o'clock, i.e. in 10 hours and 30 minutes. Select your menu,
color, loaf size then press the " "or " " to add the time until 10:30 appears
on the LCD. Then press the STOP/START button to activate this delay
program. You can see the dot flashed and LCD will count down to show the
remaining time. You will get fresh bread at 7:00 in the morning, If You don't
want to take out the bread immediately, the keeping warm time of 1hour starts.
Note: For time delayed baking, do not use any easily perishable
ingredients such as eggs, fresh milk, fruits, onions, etc.
KEEP WARM
Bread can be automatically kept warm for 60 minutes after baking. If you
would like to take the bread out, switch the program off with the START/STOP
button.
MEMORY
If the power supply has been broken off during the course of bread
making, the process of bread making will be continued automatically
within 15 minutes, even without pressing Start/stop button. If the break
time exceeds 15 minutes the memory cannot be kept and the bread
maker must be restarted，But if the dough is no further than the kneading
phase when the power supply breaks off, you can press the
"
START/STOP" straight to continue the program from the beginning .
ENVIRONMENT
The machine may work well in a wide range of temperatures, but there could
be a difference in loaf size between a very warm room and a very cold room.
We suggest the room temperature should be between 15 ℃ and 34℃.

WARNING DISPLAY:

1. If the display shows "H:HH" after the program has been started, (see below
figure 1) the temperature inside is still too high. Then the program has to be
stopped. Open the lid and let the machine cool down for 10 to 20 minutes.
2. If the display shows "E:EE" after you have pressed START/STOP, (see
below figure 2) the temperature sensor is disconnected please check the