User Interface Basics - Instrutech CVM211 User Manual

Instruction Manual
4.2

User Interface Basics

The user interface is designed for easy operation and a natural
progression of setup parameters. This section gives a brief
explanation of operation and programming parameters. A
complete user interface map is provided following this section.
The CVM211 Stinger module has four settings that can be
programmed by the user with a 3 position switch located on the
side of the module housing. Pressing the switch straight in is
referred to as pressing the <select> key. Pressing the switch
upward is referred to as pressing the <up> key. Pressing the
switch downward is referred to as pressing the <down> key.
During setup, and operation, be sure to consider the bar/mbar
LEDs.
It is important to note the unit of measure (engineering units) LED status on the front panel of the CVM211 to
correctly interpret the displayed pressure. The following table summarizes the mbar/bar LED indicator status:
Pressure Units
-3
10 mbar
mbar
bar
InstruTech
Green LED Illuminated
YES
YES
NO
CVM211 Stinger
Red LED Illuminated
YES
NO
YES
Page 12