Advertisement
*14 LCF drive sections
*15 Oil Seal (mixer shaft)
When 800k has been reached, replace the oil seals
(four) of the developer mixer shaft. When replacing,
apply grease (Alvania No.2) shown as below.
Oil seal
1. Push the new oil seal in parallel to the mounting
holes of the developer frame (or the nozzle
mixer).
* Pay attention to the direction that the oil seal is
assembled. (See figure on right.)
2. Apply a uniform coating of grease to the inside
surface of the oil seal.
• Amount:
Two large drops
• Grease:
Alvania No.2
3. Wipe off any surplus grease that oozes out from
inside.
Mixer shaft
Coat the entire periphery of the mixer shaft with
grease (Alvania No.2) and assemble the bearing.
MAY.1997 © TOSHIBA CORP.
Inside
Mixer shaft
4-12
Developer frame
(Nozzle mixer)
Outside
Grease
Oil seal
Bearing
65/5560 PERIODIC
Advertisement
