Advertisement
Available languages
Available languages
7. Slide the appliance into the framing and fi x it to the
studs on each side (6 fi xing points per side).
8. Set aside the side doors, removable panel and
barrier screen to install later when the appliance's
set-up and wall fi nish application are completed.
9. Continue the installation of the heater as indicated
the manual supplied with the heater.
Finish kit installation
Once the appliance installation is completed with
gas supply connected, liners, fuel bed and window
installed, aeration checked, remote control paired
and wall fi nish completed, fi nish the installation of the
framing kit.
1. Slide the removable panel in the clip on the
horizontal supports on each side and push it
in until fl ush with the front trim.
4
2. Identify left hand
door from right
using diagram
below.
3. Position LH
door to left side
of front frame,
identify door
LH Door
slots top and
bottom just
behind front
panel and slide
door locator in
position.
finger grip inboard,
with locator on left
4. Repeat for other door.
5. Install the barrier screen.
The tabs rest at the
bottom and the screen is
held in place by magnets.
a. Rest the bottom tabs on the edge of the
removable cover as indicated.
b. Push the screen against the steel front panel.
b
a
tabs at the
bottom
RH door has a
slot in upper
locator tab
RH Door
finger grip inboard,
with locator on right
a
Advertisement
