Weslo MOMENTUM CT 5.9 User Manual page 13

16. Apply a small amount of grease to the axle on
the right Disc Crossbar (16) and to a Large
Wave Washer (76).
Slide the Large Wave Washer (76) and the
Right Pedal Arm (12) onto the axle on the right
Disc Crossbar (16).
Slide an M10 Washer (83) onto an M10 x 25mm
Patch Screw (40), and tighten the Patch Screw
into the axle.
Then, press a Pedal Arm Cap (74) into the
Right Pedal Arm (12).
Repeat this step for the other side of the
elliptical exerciser.
17. Apply a small amount of grease to the barrel of
an M6 Bolt Set (25).
Hold the end of the Right Pedal Arm (12) inside
the bracket on the right Upper Body Leg (5).
Attach the right Upper Body Leg (5) to the Right
Pedal Arm (12) with the M6 Bolt Set (25). Do
not overtighten the Bolt Set; the right Upper
Body Leg must pivot freely.
Identify the Left and Right Upper Body Leg
Covers (80, 89), which are marked with "Left"
and "Right" stickers, and orient them as shown.
Press the tabs on the Left and Right Upper
Body Leg Covers (80, 89) together to attach
them around the right Upper Body Leg (5).
Repeat this step for the other side of the
elliptical exerciser.
See step 5. Tighten the M10 x 74mm Button
Bolts (7).
18. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
16
Grease
16
76
12
17
13
83
40
74
80
5
25
12
25
Grease
89