Turntable Motor - Panasonic NN-CT577SEPG Service Manual

After replacing component parts of the door, fol-
low the instructions below for proper installation
and adjustment of the door, this is to prevent
microwave leakage.
1. When mounting the door to the oven, adjust the
door parallel to the bottom of the oven face plate by
adjusting the upper hinge.
2. Adjust the door so there is no play between the
inner door surface and the front of the microwave
oven. If the door assembly is not mounted properly,
microwave energy may leak from the clearance
between the door and microwave oven.
3. Perform the microwave leakage test.
DOOR
HOOK
SPRING
DOOR C
figure 12 Disassembly of the door.
figure 13 Adjusting the door hinge.

9.7 Turntable Motor

1. Remove the motor cover by breaking it off at the 8
spots indicated by the arrows.
2. Disconnect the two lead wires connected to the
turntable motor.
3. Remove the 2 screws holding the turntable motor.
Note: After breaking off the motor cover, make sure no
sharp edges are exposed by trimming off the edges or
bending them inside.
Note: To secure the motor cover use a 4 x 6 screw.
DOOR A
DOOR SCREEN B
DOOR E
figure 14 Removing the turntable motor cover.
figure 15 Removing the two screws fixing the turntable
motor.
9.8 Pulley Mechanism
1.) Remove the Pulley Belt and Heater Hood.
2.) Remove Pulley A by releasing the nut and removing
the washer.
3.) Remove the Thermistor screw and re-position the
thermistor cable so as not to interfere.
4.) Remove the screw securing the Motor Bracket and
manouvre the fan cover from its housing.
14