Hanatech MULTISCAN P2 User Manual page 96

USER MANUAL
II. Operation ---------------------------------------
There are two ways you can get the gas readings using scanner interface:
Remote control mode
a
MULTISCAN P2 works as a remote control module.
All screenplays of the gas analyser are transferred to MULTISCAN P2 and you
can control the operation of the gas analyser with the scanner.
Data Stream mode
b
MULTISCAN P2 works as a data receiver.
Gas readings are provided as a part of data stream. You can view both of
scanner data stream information and gas measurements at the same time with
MULTISCAN P2.
MULTISCAN P2 must be communicating with both vehicle control module and
the gas analyser at the same time.
In either mode, gas analyser ceases to display gas measurements on its LCD
and shows the message saying "Communicating with scanner".
You have to set the gas analyser to be ready for scanner interface by selecting
[Scanner communication mode] after pressing the [MENU] key of the gas analyser
before initiating MULTISCAN P2 & gas analyser interface function. Refer to the gas
analyser manual for further information.
For MULTISCAN P2
Chapter 6 - 6