Hanatech MULTISCAN P2 User Manual page 21

Hanatech Co., Ltd.
removable by unscrewing for the fuse replacement. It may become
loose over repeated use, therefore, it is highly recommended to check if
it is tightly screwed frequently. A set of plunger parts are included in the
basic supplies. Refer to spare parts section hereinafter.
-
The rated voltage and current for this power cable are 12V and less than
2A.
6. Power cable 2 – Vehicle Battery
- Supplies power from the vehicle battery when the DLC is located in
the engine bay or when using the oscilloscope or multi-meter
functions
-
Connect each of the two
alligator clips to the battery
terminal of the correct
polarity with caution.
-
Must be used together with
the Power Cable 1. Insert
the cigarette lighter adaptor of the Power Cable 1 into the socket,
and connect the other end to the head unit.
-
Red LED light turns ON when power is properly supplied from the
vehicle battery.
(P/N. 3000-0005)
Chapter 2 - 5
Chapter 2