Troubleshooting - LifeFitness DISCOVER CONSOLE Operation Manual

T
ROUBLESHOOTING
Malfunction
No power.
Treadmill striding belt
slips
off-center.
Maximum treadmill
speed is
reduced.
Rubbing sound comes
from
underneath treadmill.
Display does not
illuminate when
machine is powered on.
Probable Cause
ON / OFF switch is not in proper position .
Power source is insuffi cient
Line cord is damaged.
Line cord is improperly seated in socket.
Note: International Platinum Club Series
Treadmills (PCST) only: You may be in
"Energy Saving Mode".
Note: International Platinum Club Series
Units only (PCSC, PCSR, PCSX): You
may be in "Energy Saving Mode".
Floor surface is uneven.
User is pushing striding belt. This occurs
when the runner is running faster than the
striding belt will travel, with the result of the
striding belt being pushed with the runner's
feet.
User is stalling striding belt. This will occur
with heavier users at lower striding belt
speeds. The striding belt will "stall" if the
user is traveling slower than the striding
belt speed.
Striding belt/deck malfunctions. The deck
laminate is worn through or the underside
of striding belt is glazed over (hard, glossy).
Power source is insuffi cient.
Foreign objects may be stuck underneath
the machine.
Loose connection at display console or mo-
tor control board.
Corrective Action
Turn the switch to the ON position.
Plug treadmill into a dedicated 20 amp circuit.
Using a voltmeter, verify power at outlet. If no
power exists, reset circuit breaker at panel.
Replace line cord. Contact Life Fitness Cus-
tomer Support Services.
Inspect power connection at wall outlet and
at machine for proper contact.
Treadmill will go into Energy Saving Mode
after 5 minutes of inactivity. To wake up
the console, step on the treadmill belt. The
treadmill will automatically wake up and the
console will light up. Waking up the treadmill
takes approximately 50 seconds after step-
ping onto the belt.
Unit will go into Energy Saving Mode after 5
minutes of inactivity. To wake up the console,
pedal until you hear a beep. The unit will au-
tomatically wake up and the console will light
up. Waking up the unit takes approximately
50 seconds after beginning to pedal.
Check levelers and level treadmill. Check
striding belt & re-tension as necessary. Refer
to Elevation Series 95T Treadmill Assembly
Instructions.
Instruct users not to push striding belt in
either direction.
Replace belt and deck. Contact Life Fitness
Customer Support Services.
Plug treadmill into a dedicated 20 amp circuit.
Inspect underneath striding belt and ma-
chine. Remove any debris or objects that
may cause interference with the treadmill.
Check all electrical connections for proper
attachment. Contact Life Fitness Customer
Support Services.
73