System Reset - Sangean RCR-20 Manual

Important:
● The charger may not supply power to some USB devices.
● When not using or after charging, remove the USB cable.
● Do not connect power source to USB port. Otherwise there is a risk of
fire. The USB port is only intended for charging lower voltage device.
● Do not insert a nail, wire, etc. into the USB power supply port. Otherwise
a circuit short may cause smoke and fire.
● Do not connect this USB socket with your PC USB port, as it is highly
possible that it may cause breakdown of the units.
● Never use the USB socket in rainy or moist conditions to prevent moisture
from entering the radio.
25

System reset

If your radio fails to operate correctly, or some digits on the display are
missing or incomplete carry out the following procedure.
1. When the radio is in power on or standby mode, press and hold the
Info/Menu button until you hear a beep to enter the menu setting.
2. Rotate the Tuning control knob until "FACTORY" appears on the display.
Press and release the Tuning control button, the "RESET NO" will appear
on the display and "NO" will flash. Rotate the Tuning control knob to
select "NO" or "YES". If you do not wish to carry out a system reset,
select "No" and then press the Tuning control button. The display will
revert back to the previous display.
3. To select "YES", press and release the Tuning control button. A full reset
will be performed. The station presets will be erased. Alarms will be
cancelled and the sleep timer settings will be set to their default values.
All the icons will show on the display and the radio will turn off automatically.
In case of malfunction due to electrostatic discharge, reset the product
(reconnection of the power source may be required) to resume normal
operation.
4. You may also elect to unplug your radio for at least 12 hours to reset
your radio.