Sangean RCR-20 Manual page 25

Software version/Setting tuning step/FM range setting
Software version
The software version display cannot be altered and is just for your reference.
1. Turn off the radio.
2. Press and hold the Source button until you hear a beep and the software
version (e.g. VER XXX) is shown on the display.
Setting tuning step
1. After the software version is shown on the display, rotate the Tuning
control knob until FM xkHZ or AM xkHZ appears on the display, and
press the Tuning control button to enter FM or AM step setting. The
"xkHZ" will flash on the display.
2. Rotate the Tuning control knob to select 50 kHz/100 kHz for FM radio,
and 9 kHz/10 kHz for AM radio. Then press the Tuning control to confirm
the setting.
Note:
The tuning steps for North America are FM: 100 kHz and AM: 10 kHz
The rest of the world is FM: 50 kHz and AM: 9 kHz
Note:
Change in the AM tuning step setting will result in the removal of AM
presets stored in the radio, this is not the case for your FM tuning steps.
FM range setting
The FM Broadcasting Band tuning range can be different depending on
where in the world you live. It may be necessary to adjust the FM range to
allow the radio to work properly.
1. After the tuning step setting is completed, rotate the Tuning control knob
until the FM frequency range shows on the display. Then press the Tuning
control button to enter the FM range setting.
2. Rotate the Tuning control knob to select the desired FM range and
press the Tuning control button to confirm the setting.
The available FM range is as following:
FM: 87.5-108 MHz (North America) (default) Your radio is pre-set with
this tuning range, no adjustments are necessary if you live in North
America.
FM: 76-90 MHz (for Japan)
FM: 64-108 MHz (for Eastern European countries and Russia)
FM: 76-108 MHz (for some of China area and European countries)
USB socket for iPhone/Smartphone charging
Your radio has a USB socket which is intended only for charging
an iPhone, smart phone or similar devices. Charge time may vary
and in some cases may take longer to charge than when using the
manufacturers charging unit supplied with the smart phone.
1. The radio can charge the iPhone, smart phone or similar devices when
the radio is in power on or standby mode and in FM/AM radio mode, BT
mode or AUX IN mode.
2. Connect your smart phone to the USB charging socket on the rear of
your radio.
3. Your iPhone or smart phone will begin to charge.
4. Once your iPhone or smart phone has fully charged remove the USB
cable.
Note:
Charging mobile phones (for example) or other devices may affect the
listening quality while listening to the AM/FM band.
GB
24