Sangean RCR-20 Manual page 13

Presetting stations in AM/FM mode
There are 5 preset stations each for AM and FM radio. They are used in the same way for each
frequency band.( Please note that 9 memory presets for each band can be accessed via remote
control.)
1. Press the Standby (main power) button to switch on your radio.
2. Press the Source button to select the desired frequency band. Tune to the required radio station
as previously described.
3. Press and hold the required Preset button until the display shows "P4" for example after the
frequency. The station will be stored using the preset number. Repeat this procedure for the
remaining presets as you wish.
4. Preset stations which have already been stored may be overwritten by following the above
procedure if required.
Recalling a preset in AM/FM mode
1. Press the Standby (main power) button to switch on your radio.
2. Select the required frequency band by pressing the Source button.
3. Momentarily press the required Preset button to have your radio tune to one of the stations stored
in the preset memory.
Note: The display will show "EMPTY" if no station has been stored to that preset.
GB
12