Cleaning The Filters In The Water Inlet - Miele PG 8536 Operating Instructions Manual

Cleaning the filters in the water
inlet
Filters are incorporated in the screw
connection of the water inlet hose to
protect the water inlet valve. If these
filters get dirty they need to be cleaned,
otherwise insufficient water flows into
the wash cabinet.
,
The plastic housing of the water
connection contains an electrical
component. It must not be dipped in
water.
Problem solving
To clean the filter
^ Disconnect the machine from the
mains electricity supply
^ Turn off the stopcock and unscrew
the water inlet hose.
^ Clean the large area filter (1) and fine
filter (2), and replace with new filters
if necessary.
^ Replace filters and the seal. Make
sure they are sitting correctly.
^ Reconnect the inlet hose to the
stopcock, making sure it goes on
correctly and is not cross-threaded.
^ Open the stopcock gradually to test
for leaks.
If water leaks out the connection may
not be tight enough or the hose may
have been connected incorrectly.
^ Reconnect the hose correctly and
tighten it.
63