Process Documentation - Miele PG 8536 Operating Instructions Manual

This washer-disinfector can be set up
to document processes used.
This can be recorded by either using
external software for process
documentation or an external printer.
The washer-disinfector is equipped with
two RJ45 connectors on the back for
connecting to Process documentation
software or a printer.
The interface configuration is
described in section "PC/Printer
function" of the Programming
manual.
Process documentation using
external software
The "Ethernet" connection is used for
transfering process reports and
temperature graphs to the external
software.
A straight-through ethernet cable is
required for connecting the
washer-disinfector with suitable network
components (e.g. hub, switch).
A cross-over ethernet cable is required
for a direct ethernet connection
between the washer-disinfector and an
external appliance.

Process documentation

Process documentation using an
external printer
The connector marked "Printer" is used
for connecting an external printer to the
serial interface.
An RJ45 / Sub-D adapter is needed for
connecting the washer-disinfector to
the external printer via an RS 232
interface.
Instructions on how to set the print
functions of an external printer are
given in section "PC/Print functions" in
the Programming manual.
Please note the following when
connecting a printer or PC:
– Only use an industry-standard PC or
printer (EN/IEC 60950, Australia and
New Zealand: AS/NZS 60950).
– The size of the printer or PC must be
taken into account when installing
the machine.
– The maximum length for an extension
cable from the serial interface to the
printer or PC is 10 m and from the
ethernet interface 100 m.
Please contact Miele if you require
further information about suitable
printers and software.
53