Pyle PIPCAMHD82 Quick Start Manual page 4

WIRED SETUP
1.
Plug your camera into AC power
2.
Plug your camera directly into
your router with wired Ethernet wire
(included)
NOTE:
Wired Ethernet is required for
setup. Wireless will be configured later.
NOTE:
Wait 2-3 minutes for camera
to boot. You will see the camera run
through a full range of pan and tilt
motion.
3.
When boot up completes, your
camera's ethernet port will flash yellow
and green lights indicating the camera is
connected to your router.
NOTE:
If lights are not flickering the
camera is not receiving data. Please
check for faulty ethernet cable and that
your router is working with another
device.
4.
Check that you have WIFI enabled in
your phone's system settings