Samsung AC***KNZDCH/AA Installation Manual page 37

Setting the indoor unit option code
In order to set the indoor unit option code use the wired remote controller and follow the directions below.
Main Menu Sub-menu
Press the and buttons at the same time for more than 3 seconds and then a Main menu will be displayed.
1. Press the / button to select
2. Press the / button to select
The first digit represents the page number and the remaining five digits are option codes.
NOTE
The option code which is currently setting will flicker.
/
3. Press the button to set the option code in order. Press
4. Press the button to save and complete the option setting.
5. Press the button to exit to normal mode.
Press the button anytime during setup to exit without setting.
NOTE
Option code will not be applied if you don't press the
CAUTION
Setting indoor unit option code is only possible in Master wired remote controller. You can only check the
indoor unit option code in Slave wired remote controller.
Setting indoor unit option code is possible when one indoor unit is connected. If more than 2 indoor units are
connected, you can only check the Master indoor unit option code.
Data bit
1 2 3 4 5 6
and then press button to enter a Sub-menu setting screen.
and then press button to enter a Indoor unit option code setting screen.
37
Page number Option Code
1 2 3 4 5 6
SEG1 SEG2 SEG3 SEG4
✴ ✴ ✴
0
Page number
SEG7 SEG8 SEG9 SEG10
✴ ✴ ✴
1
Page number
SEG13 SEG14 SEG15 SEG16
✴ ✴ ✴
2
Page number
SEG19 SEG20 SEG21 SEG22
✴ ✴ ✴
3
Page number
button to go to the next page.
SEG5 SEG6
✴ ✴
SEG11 SEG12
✴ ✴
SEG17 SEG18
✴ ✴
SEG23 SEG24
✴ ✴