Table of Contents
Advertisement
Performing
NOTE
5 The sounds recalled by right registers
which Set is currently selected.
"Using Sets"
For details, refer to
5 If you hold down one of the right hand register buttons, the
selected part is muted, and no sound is heard when you play
the keyboard (keyboard data is only transmitted via MIDI).
Press the right hand register button once again to cancel
muting.
About Organ Sounds (VTW)
The FR-4x contains a virtual organ that is based on Roland's Virtual
Tone Wheel technology.
You can play organ sounds like an organ player by using the Right
Hand (TW Upper), Left Hand chord and Bass sections (TW Lower,
TW Pedal).
You are free to assign an organ sound to just one section, to two, or
to all three of them.
to"Right Hand Organ Part Parameters
For more details, refer
(Organ Edit)"
(p. 56),
"Left Hand Orchestra Bass Part Parameters
(Orchestra Bass Edit)"
(p. 57) and
Part Parameters (Orchestra Chord Edit)"
Playing Multiple Tones with the Keyboard
You can perform with up to two layered tones applied to the entire
keyboard.
To do this you can select more than one section simultaneously by
pressing the desired RIGHT HAND buttons at the same time and by
assigning one tone to each of these layers.
ACCORDION Section
ORCHESTRA Section or ORGAN Section
MEMO
You have the possibility to change the key range of each
section.
In this way you can play the Accordion section in the lower
part of the keyboard and the Orchestra section in the higher
part.
&
"Assigning a Portion of Right Hand Keyboard to Each
Section"
(p. 27)
ACCORDION Section
NOTE
The Organ section and the Orchestra section cannot be used
at the same time.
22
[1]–[14]
depend on
(p. 33).
"Left Hand Orchestra Chord
(p. 60).
ORCHESTRA Section
1
Press simultaneously two RIGHT HAND buttons to
select the section combination that you want to
play.
The combination of the RIGHT HAND sections are shown in the
table just below.
What you want to play
ACCORDION + ORGAN
ACCORDION + ORCHESTRA
The buttons of the selected sections light.
* If multiple tones are selected for more than one part, you can use
the right hand register buttons
the last-selected part.
2
Play the keyboard.
You'll hear a sound in relation to the sections you selected earlier.
The active sections play in relation to the selected Keyboard Mode.
At default the Keyboard Mode parameter value is set to
and all sections play on the whole extension of the keyboard.
For more detail about the Keyboard Mode see
Parameters for the Right Hand Keyboard (Right Hand Mode)"
(p. 69)
Reselecting the part and switching the sound
You can have more than one active section but only one of them is
active for changing the tone.
If you want to switch to a sound that's different from the selected
part, reselect the part and then switch the sound.
3
Press and hold the button of one active section
where you want to change the tone, as long as it
starts flashing.
The right-most three digits in the upper line of the screen show the
part whose sound you're changing.
5 (Blank): Accordion (Treble) Part
5 o: Orchestra Part
5 r: Organ Part
In the above example the
changing tone.
4
Use the right registers
sounds belonging to the selected section.
NOTE
The sounds recalled by right registers
which Set is currently selected.
&
"Using Sets"
(p. 33)
Press and hold simultaneously
[ACCORDION]
and
[ORGAN]
button
[ACCORDION]
and
[ORCHESTRA]
button
[1]–[14]
to change the sound of
"Keyboard Mode
"ACCORDION"
section is active for
[1]–[14]
to select other
[1]–[14]
depend on
"Zone"
Advertisement
Table of Contents
