Troubleshooting; Reset Function - Sony KV-DR29M93 Service Manual

x

Troubleshooting

If you have any problem while viewing your TV, you can either use the Reset
function or check the Troubleshooting guide below. If the problem persists,
contact your Sony dealer.
RESET
RESET
Troubleshooting guide
Symptom
• The connection is loose
Snowy picture
• The antenna setup is
• Channel presetting is
Noisy sound
• Signal transmission is
• Broadcast signals are
Distorted picture
Noisy sound
• The TV system setting
Good picture
• PIP sound is selected
Noisy sound
32
Additional Information

Reset function

Press the RESET button on your remote control.
Your TV will go blank for about half a second
then the picture will reappear with "RESET"
TV
displayed on your TV screen for about 10 seconds.
Pressing RESET will set your TV to the factory
setting, but certain problems may be solved.
Possible cause
or the cable is
damaged.
inappropriate.
inappropriate or
incomplete.
low.
too strong.
is inappropriate.
when PIP is displayed
(KV-DR34M97 only).
Solutions
• Check the antenna cable and connection
on the TV, VCR and at the wall.
• Check the antenna setup.
Contact a Sony dealer for advice.
• Display the "CH PRESET" menu and
select "MANUAL PROGRAM" to preset
the channel again.
• Try using a booster.
• Display the "CH PRESET" menu and
select "MANUAL PROGRAM".
Then, select " SENS: LOW"
(KV-DR34M97 only).
• Turn off or disconnect the booster if it is in
use.
• Display the "CH PRESET" menu and
select the appropriate TV system
("TV SYS").
• Press SOUND or .
Page
30
–
28
–
29
–
28
13