EUROSTER 11E USER MANUAL
CENTRAL HEATING/UTILITY HOT WATER SYSTEM PUMP CONTROLLER
MANUFACTURER: P.H.P.U. AS, Polanka 8a/3, 61-131 Poznań, POLAND
1
INTRODUCTION
Carefully study this user manual to learn how to correctly operate the EUROSTER 11E central
heating/utility hot water system pump controller.
2
FIELD OF APPLICATION
EUROSTER 11E is a modern microprocessor-based controller used to control central heating
(CH) system pump or utility hot water (UHW) system pump.
The EUROSTER 11E controller features the ANTY STOP
function that prevents idle pump rotors against seizing. Once
the heating season is over, every 14 days the function
automatically turns ON the pumps for 30 seconds. To that
end the controller must be left powered up.
3
VISIBLE CONTROLLER ELEMENTS
4
INSTALLATION
Hazardous voltages may be present inside the controller and on its cables.
Therefore it is expressly forbidden to install the device prior to disconnecting
its mains power supply. Only qualified technicians may install the controller.
Do not install any devices showing signs of any mechanical damage.
The procedure:
a) Mount the controller:
using a pair of supplied nylon nail-it fasteners (anchors) mount the controller box on a
EUROSTER 11E
1. 230 VAC~ mains input
2. 230 VAC~ power supply to pump
3. Input for temperature sensor cable
4. Mains switch
5. LCD display
6. Knob
1
Need help?
Do you have a question about the 11E and is the answer not in the manual?
Questions and answers