Before Making Copies
5.5
Selecting the Paper Source
The paper used for making copies can be selected in two ways.
G
Auto Paper:
If the Auto Paper function is selected, the paper tray containing the
most suitable size of paper is selected based on the size of the
document and the specified zoom ratio.
G
Manual paper selection:
The paper that you wish to use for copying can be selected.
To make copies using the Auto Paper function
1
Load the document into the Automatic Document Feeder.
Refer to "Loading the Document" on page 3-8.
H
2
Press the [Auto Paper/Auto Size]
key until the Auto Paper function is
selected.
H
Check that "AUTO" appears in
the bottom line of the screen.
3
If necessary, specify any other copy
settings.
H
Zoom (p. 5-22)
H
Copy density (p. 5-26)
H
Advanced Copy Operations (p. 6-1)
4
Using the 10-Key Pad, enter the desired number of copies, and then
press the [Start] key.
Note
If "NO SUITABLE PAPER" appears in the display immediately after
the [Start] key is pressed, no tray is loaded with paper of the most
suitable size. Either load paper with the appropriate size, or press the
[Paper] key and select the desired paper size, and then press the
[Start] key again.
D 1650iD/D 2050iD
5
5-17
Need help?
Do you have a question about the D 1650iD and is the answer not in the manual?