Ec Declaration Of Conformity - Makita DF011D Instruction Manual

CLEANING AND MAINTENANCE
WARNING!
Do not press the On/Off switch when performing cleaning and maintenance procedures.
CAUTION:
Never use gasoline, benzine, thinner, alcohol or the like.
Discoloration, deformation or cracks may result.
After use, remove the screwdriver bit and tap the side of the screwdriver bit holder to remove any dust, or chippings etc.
Clean the body of the screwdriver with a soft cloth. Keep the handle clean and free from oil and grease.
Keep the charging adaptor clean and free from dust and grease. Worn or damaged parts must be replaced by qualified
personnel. There are no user servicable parts inside the screwdriver. Refer to qualified service personnel if internal
maintenance is required. Always store the screwdriver and the charging adaptor in the carrying case.
Noise
The typical A-weighted noise level determined according to EN60745:
Sound pressure level (L
Uncertainty (K): 3 dB (A)
The noise level under working may exceed 80 dB (A).
Vibration
The vibration total value (tri-axial vector sum) determined according to EN60745:
Work mode: screwdriving without impact
Vibration emission (a
Uncertainty (K): 1.5 m/s
• The declared vibration emission value has been measured in accordance with the standard test method and may be
used for comparing one tool with another.
• The declared vibration emission value may also be used in a preliminary assessment of exposure.
WARNING:
• The vibration emission during actual use of the power tool can differ from the declared emission value depending on
the ways in which the tool is used.
• Be sure to identify safety measures to protect the operator that are based on an estimation of exposure in the actual
conditions of use (taking account of all parts of the operating cycle such as the times when the tool is switched off and
when it is running idle in addition to the trigger time).
For European countries only

EC Declaration of Conformity

We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s):
Designation of Machine:
In-Line Cordless Screwdriver
Model No./ Type: DF011D
are of series production and
Conforms to the following European Directives:
2006/42/EC
And are manufactured in accordance with the following standards or standardised documents:
EN60745
The technical documentation is kept by our authorised representative in Europe who is:
Makita International Europe Ltd.
Michigan Drive, Tongwell,
Milton Keynes, Bucks MK15 8JD, England
): 70 dB (A) or less
pA
2
): 2.5 m/s or less
h
2
3-11-8, Sumiyoshi-cho,
Anjo, Aichi, 446-8502, JAPAN
Wear ear protection.
30. 1. 2009
Tomoyasu Kato
Director
Makita Corporation
ENG905-1
ENG900-1
ENG901-1
ENH101-15
9