Operational Environment; Preparation For Operating New Or Overhauled Engine; Preparation Of Fuel System - Mitsubishi S16R-Y1PTA Operation & Maintenance Manual

Operational environment

Check that the following contents are performed before the engine is operated. Failure to do so may cause various
problems and will shorten the service life of the engine.
ŒPrevent from spreading water (especially, seawater or rainwater) and entering foreign materials to the air inlet
opening.
ŒPrevent from entering foreign materials to the rotating parts.
ŒPrevent from attaching water and dust to the electrical system.
ŒUse the engine at 5 to 40 °C [41 to 104 °F].

Preparation for operating new or overhauled engine

Before proceeding with operation of a new overhauled engine, conduct the inspections described in this section.
For second operation onward, follow the instructions described in the

Preparation of fuel system

When handling fuel, make sure there are no open flames or other fire hazards near the engine.
Wipe off any spilled fuel completely. Spilled fuel can ignite and cause a fire.
Do not remove the strainer when filling the fuel tank.
For fuel to be used, refer to
1. Make sure the insides of the fuel tank and fuel supply pipes to the engine are thoroughly clean.
2. Fill fuel tank with fuel.
3. Remove the fuel feed pipe and drain plug from the fuel inlet of engine, and check the discharged fuel for foreign
materials such as dust.
4. Reinstall the drain plug and the fuel feed pipe.
5. Refill fuel tank until fuel level gauge indicates "FULL" level line.
Chapter 3 OPERATION
"FUEL" (4-1).
"Normal engine operation" (3-7).
3-1