Troubleshooting Table - Echo DSRM-300 Original Instructions Manual

Maintenance and care

Troubleshooting table

 For spare parts and consumables, please use only genuine parts and designated products and components.
Using parts from other manufacturers or non-designated components may result in a malfunction.
Trouble
Red Charger light flashes or does not
light up
Unit will not turn on
Unit does not run when turned on
Running time is too short
Line won't feed
Line fails to cut off
 Consult your dealer in the event of a problem that is not covered in the table above, or other such concerns.
 Please contact your dealer in order to dispose of the product or its parts in compliance with national laws.
8. Pull out the line from cover. (A) Remove the line from "re-
spective notch of spool", and (B) pass it through "groove of
respective eyelet".
9. Fit cover and housing together. (C) Align "eyelets" of cover
with "recesses" of housing, and (D) press pawls of housing
into respective window of cover until the pawls are firmly fit-
ted into the windows.
Make sure each outer periphery of pawls of housing
spreads almost fully up to the outer periphery of respec-
tive window of cover. If they are loosely fitted and the cut-
ting head is turned, cover or inside components can fly off
which is dangerous.
IMPORTANT
Cause
1. Plug not connected to power outlet
2. Battery pack not installed properly
3. Obstructed connection
4. Fault in the charger
5. Fault in the battery pack
1. Battery pack not installed properly
1. Battery pack discharged
2. Line head obstructed
3. Battery pack outside acceptable
temperature range
1. Battery pack outside acceptable
temperature range
2. Unit electronics too hot
3. Battery pack discharged
1. Not enough line on the spool
2. Line tangled in the spool
1. Cut off knife in the shield is damaged
or missing
20
DANGER
Remedy
1. Plug in the charger
2. Check the battery pack installation
3. Reinstall battery pack again after re-
moving obstructions from connec-
tion.
4. Consult your dealer
5. Consult your dealer
1. Check the battery pack installation
1. Charge the battery pack
2. Turn off the unit and clean the cut-
ting attachment
3. Remove the battery pack and allow
to cool
1. Remove the battery pack and allow
to cool
2. Turn unit off and allow to cool
3. Charge the battery pack
1. Rewind with new line
2. Unwind and rewind the line
1. Consult your dealer