Troubleshooting - Pentax Optio T30 Operating Manual

Troubleshooting

Troubleshooting
Problem
Camera will not
turn on
No image on LCD
monitor
7
Shutter will not
release
172
Cause
Battery is not installed
Battery is installed
incorrectly
The battery is exhausted Charge the battery (p.14).
The battery performance
has temporarily
deteriorated because it is
too cold
Camera is turned off
Camera is connected to a
computer
Camera is connected to a
TV
Display mode is set to Off
Power Saving function
has activated
Image is displayed but is
hard to see
Flash is charging
No available space on SD
Memory Card or in the
built-in memory
Recording
Solution
Check if a battery is installed. If not,
install battery (p.15).
Check orientation of battery. Reinsert
battery (p.15).
Warm up the battery by placing it in a
pocket where it can come in contact
with body heat.
Turn the camera on (p.20).
The LCD monitor turns off when the
camera is connected to a computer.
The LCD monitor turns off when the
camera is connected to a TV.
Touch the LCD monitor to change the
display mode setting (p.41).
Deactivate by pressing the shutter
release button halfway in Capture
mode.
Increase the brightness of the LCD
monitor (p.162).
Pictures cannot be taken while the
flash is charging. Wait until charging is
finished.
Insert SD Memory Card with available
space or delete unwanted files (p.17,
p.102). Change the picture size or
quality or both and try again (p.54,
p.108).
Wait until recording is finished.