TO X2
Enter the to point for X. Press ENT.
TO Y2
Enter the to point for Y. Press ENT.
DEPTH
Enter the cut depth. Press ENT.
TOOL OFFSET
Enter the tool offset. Press ENT.
Press USE.
Milling an Arc
In the operating mode PROGRAMMING you can use the POSITIP 880 for
milling an arc. See Fig. I.50.
There are two ways you can program an arc:
With a from point, to point and a radius
With a from point, to point and a center point
Choose a method based upon the information available from your
print.
64
Fig. I.50 MILL ARC form
I Operating Instructions