Removal Of Dvd Deck Parts - Sanyo DP26671 Service Manual

2. REMOVAL OF DVD DECK PARTS

NOTE
1. Disassemble only the DVD DECK PARTS parts listed
here. Minute adjustments are needed if the
disassembly is done. If the repair is needed except
listed parts, replace the DVD MECHA ASS'Y.
2-1: TRAVERSE ASS'Y/LOADER SUB ASS'Y
(Refer to Fig. 2-1-A)
1. Remove the 3 screws (1).
2. Remove the Traverse Ass'y.
(1)
Traverse Ass'y
Loader Sub Ass'y
• Screw Torque: 3.0 ± 0.3kgf•cm (screw(1))
NOTE
1. In case of the Traverse Ass'y installation, hook the wire
on the Loader Ass'y as shown Fig. 2-1-B to Fig. 2-1-C.
Loader Ass'y (Top side)
Check Lock
Check Lock
DISASSEMBLY INSTRUCTIONS
(1)
(1)
Fig. 2-1-A
Check Lock
Check Lock
Check Lock
Fig. 2-1-B
Check Lock
Check Lock
2.2: FEED RACK ASS'Y/GEAR FEED/GEAR MOTOR/
GEAR MIDDLE/FEED MOTOR/PCB630
(Refer to Fig. 2-2-A)
1. Remove the screw (1).
2. Remove the Feed Rack Ass'y.
3. Remove the screw (2).
4. Remove the Gear Feed.
5. Remove the Gear Middle.
6. Remove the Gear Motor.
7. Remove the 2 screws (3).
8. Remove the Feed Motor.
9. Unlock the support (4).
10. Remove the PCB630. 10. Remove the PCB630.
Gear Motor
Gear Middle
(3)
PCB630
(4)
• Screw Torque: 1.3 ± 0.3kgf•cm (Screw (1))
• Screw Torque: 1.0 ± 0.3kgf•cm (Screw (2))
• Screw Torque: 1.0 ± 0.3kgf•cm (Screw (3))
B2-1 B2-1
Gear Feed
(1)
(2)
Feed Rack Ass'y
(3)
Chassis
Feed Motor
Fig. 2-1-C
Fig. 2-2-A