Table of Contents
Advertisement
NOTE
1. In case of the Gear Motor installation, check if the value
of the Fig. 2-2-B is correct.
2. When installing the wire of the PCB630 install it correctly
as Fig. 2-2-C.
Manual soldering conditions
• Soldering temperature: 350 ± 5
• Soldering time: Within 4 seconds
• Soldering combination: Sn-3.0Ag-0.5Cu
3. When installing the Feed Rack Ass'y, push both ends to
align the teeth as shown Fig. 2-2-D. Then install it.
4. After the assembly of the Traverse Ass'y, hook the wire
on the Traverse Ass'y as shown Fig. 2-2-E.
Gear Motor
Feed Motor
Safety surface for pressing of the insert.
PCB630
PCB630
~FEED MOTOR~
WHITE
GREEN
Feed Rack Ass'y
Push
(OK)
DISASSEMBLY INSTRUCTIONS
o
C
7.0 ± 0.1mm
Fig. 2-2-B
YELLOW
BLACK
~SPINDLE MOTOR~
Fig. 2-2-C
Push
(NG)
Fig. 2-2-D
TOP SIDE
Check Hook
Traverse Ass'y
• In case of remove FEED MOTOR that has to arrange wire as following
the picture on above.
2.3: SPRING SHUTTER/PLATE HOLDER/SHUTTER ROLLER
ASS'Y/ROLLER ASS'Y/GEAR ROLLER/LUMIRROR WASHER/
ROLLER CONE/SHAFT ROLLER
(Refer to Fig. 2-3-A)
1.
Remove the Spring Shutter.
2.
Remove the screw (1).
3.
Unlock the support (2).
4.
Remove the Plate Holder.
5.
Remove the Shutter Roller Ass'y.
6.
6
Remove the Roller Ass'y
Remove the Roller Ass y .
7.
Remove the Gear Roller.
8.
Remove the Lumirror Washer.
9.
Remove the Roller Cone.
10. Remove the Shaft Roller.
Spring Shutter
Lumirror Washer
Gear Roller
Roller Cone
Shaft Roller
Frame Ass'y
• Screw Torque: 3.0 ± 0.3kgf•cm (Screw (1))
B2-2
4 PIN FFC
Check Hook
Check Hook
Fig. 2-2-E
(1)
Plate Holder
(2)
Shutter Roller Ass'y
Roller Cone
Lumirror Washer
Fig. 2-3-A
Advertisement
Table of Contents
