Sanyo DP26671 Service Manual page 22

NOTE
1. In case of the Shutter Roller Ass'y installation,
check if the value of the Fig. 2-3-B is correct.
2. In case of the Roller Cone installation, install correctly as
Fig. 2-3-C.
3. In case of the Lumirror Washer installation,
install correctly as Fig. 2-3-D.
4. In case of the Gear Roller installation, check if the value
of the Fig. 2-3-E is correct.
Spring Shutter
Plate Holder
(OK)
Roller Sub Ass'y
(OK)
DISASSEMBLY INSTRUCTIONS
Check Hook
(NG)
Fig. 2-3-B
(NG)
Fig. 2-3-C
Safety surface for
pressing of the insert.
Roller Sub Ass'y
2.4: RACK BASE/GEAR MIDDLE4/BELT LOADING/GEAR PULLEY/
GEAR MIDDLE3/GEAR MAIN/GEAR MIDDLE1/GEAR MIDDLE2/
LOADING MOTOR/PULLEY MOTOR/CLAMPER/MAGNET/
PLATE CLAMPER/SPRING LIFTER/PLATE LIFTER/LEVER GUIDE/
LOADING MOTOR PCB/RACK DISC SENSOR R/RACK DISC LOADING MOTOR PCB/RACK DISC SENSOR R/RACK DISC
SENSOR L/SPRING RACK D SENSOR/GEAR RACK DISC
(Refer to Fig. 2-4-A)
1. Remove the 2 screws (1).
2. Remove the Rack Base.
3. Remove the Gear Middle 4.
4. Remove the Belt Loading.
5. Remove the Gear Pulley.
6. Remove the Gear Middle 3.
7. Remove the Gear Main.
8. Remove the Gear Middle 1.
9. Remove the Gear Middle 2.
10. Remove the 2 screws (2).
11. Remove the Loading Motor.
12. Remove the Pulley Motor.
13. Remove the Clamper.
14. Remove the Magnet.
15. Remove the Plate Clamper.
16. Remove the Spring Lifter.
17. Remove the Plate Lifter.
18. Remove the Lever Guide.
19. Remove the Loading Motor PCB.
20. Remove the Rack Disc Sensor R.
21. Remove the Rack Disc Sensor L.
22. Remove the Spring Rack D Sensor.
23. Remove the Gear Rack Disc.
B2-3
Roller Sub Ass'y
(OK) (NG)
Fig. 2-3-D
0 ± 0.1 mm
Fig. 2-3-E