Replacing Tires - Ikco Pickup Owner's Manual

REPLACING TIRES

Wheels replacement
5
- Put the vehicle at the flat level, after
pulling the handbrake put the automobile
at gear one or reverse gear
- The hazard warning triangle is placed
under the seat (according to announced
space on the caution box) to procure the
safety issues while replacing the wheel (2
on previous page)
- Remove jack and the wheel brace
- Open the spare wheel strap and remove
the spare wheel
- Loose the wheel nuts and remove the
wheel trim(wheel cover)by using wheel
brace
80
- Put the Jack at a special place (1) and
raise the vehicle by turning the jack in
clockwise direction
- Unscrew the wheel nuts and remove the
wheel
- Replace the spare wheel
- Tighten the nuts a little
- Lower and remove the jack
- Tighten all nuts completely
- Replace the wheel trims(wheel cover)
- Put the punctured tires in the place of
spare wheel and tighten the strap
- Replace the tires, according to the ( 2 )for
each 8000 kilometers.
Caution
- The wheels must be balanced.
- Never use jack to repair while going
under the vehicle
- To regulate the safety issues, check the
air pressure of the wheels, including spare
wheel, while the tires are cold.
Warning
Do not get under your vehicle if it is
supported only with jack. Jack is only for
changing wheels.
- Check the tire pressure after changing
wheels and make sure the wheel nuts are
tightened
- Replace the wheel as soon as it is
deflated.
- Deflated tire should be inspected (and
repaired if necessary) by an expert.
- Park the vehicle on level, stable and non-
slippery ground (for example avoid parking
on the ceramic surface), (use a bulkhead
under jack shoe if necessary), turn on the
flasher blinker light. Apply hand brake and
engage first or reverse gear or position
P for automatic gearbox. All occupants
should be go out of the vehicle to a place
far from vehicle traffic.